To the top

Page Manager: Webmaster
Last update: 9/11/2012 3:13 PM

Tell a friend about this page
Print version

Time resolved imaging of … - University of Gothenburg, Sweden Till startsida
Sitemap
To content Read more about how we use cookies on gu.se

Time resolved imaging of the non-linear bullet mode within an injection-locked nano-contact spin Hall nano-oscillator

Journal article
Authors T. M. Spicer
P. S. Keatley
Mykola Dvornik
T. H. J. Loughran
Ahmad Awad
Philipp Dürrenfeld
Afshin Houshang
Mojtaba Ranjbar
Johan Åkerman
V. V. Kruglyak
R. J. Hicken
Published in Applied Physics Letters
Volume 113
Issue 19
ISSN 0003-6951
Publication year 2018
Published at Department of Physics (GU)
Language en
Links dx.doi.org/10.1063/1.5047148
Keywords Physics
Subject categories Physical Sciences

Abstract

Time-resolved scanning Kerr microscopy (TRSKM) has been used to image precessional magnetization dynamics excited by a DC current within a nano-contact (NC) spin Hall nanooscillator (SHNO). Injection of a radio frequency (RF) current was used to phase lock the SHNO to TRSKM. The out of plane magnetization was detected by means of the polar magneto optical Kerr effect (MOKE). However, longitudinal MOKE images were dominated by an artifact arising from the edges of the Au NCs. Time resolved imaging revealed the simultaneous excitation of a nonlinear "bullet" mode at the centre of the device, once the DC current exceeded a threshold value, and ferromagnetic resonance (FMR) induced by the RF current. However, the FMR response observed for sub-critical DC current values exhibits an amplitude minimum at the centre, which is attributed to spreading of the RF spin current due to the reactance of the device structure. This FMR response can be subtracted to yield images of the bullet mode. As the DC current is increased above threshold, the bullet mode appears to increase in size, suggesting increased translational motion. The reduced spatial overlap of the bullet and FMR modes, and this putative translational motion, may impede the injection locking and contribute to the reduced locking range observed within NC-SHNO devices. This illustrates a more general need to control the geometry of an injection-locked oscillator so that the autonomous dynamics of the oscillator exhibit strong spatial overlap with those resulting from the injected signal. Published by AIP Publishing.

Page Manager: Webmaster|Last update: 9/11/2012
Share:

The University of Gothenburg uses cookies to provide you with the best possible user experience. By continuing on this website, you approve of our use of cookies.  What are cookies?